Archgard Optima 40 Spécifications télécharger pdf (Page 13)

Optima 40 - SB 13

SURROUND INSTALLATION

Make sure the gas and electrical lines are properly connected to the appliance. Slide the unit

into the fireplace and slide the excess flue liner material back onto the chimney. Before the

appliance is fully recessed into the fireplace attach the surround onto the appliance. The return

flange on the side of the surround fits on the inside of the mounting rails on the appliance.

Attach the surround to the appliance at the locations shown with the four (4) screws provided.

Then finish with the wiring connection to the on/off switch on the side of the trim. Now fully

“seat” the unit into its final position.

SCREW

LOCATIONS

CAUTION:

Only trim kit (s) supplied

by the manufacturer may

be used in the installation

of this appliance.

1. Using the trim clips provided, join the left side trim (which has notch cut for rocker switch)

to the top trim as shown in Fig.1. Repeat with the right side trim.

2. Peel the backing from the sticky tape, then slip the assembled trim over the surround.

3. Locate the rocker (on/off) switch (with the ON side up) and push it in the notch located on

the left side.

4. Remove the coiled wires from the left side of the firebox and connect it to the rocker

switch tabs.

5. The switch wires have crimped connections that are factory installed. Simply connect the

crimped connections to the on/off (rocker) switch located on the surround.

TRIM INSTRUCTIONS FOR THE SKBAB, SKCAB & SKLB SURROUNDS

Fig. 1

Fig. 2

Fresh Air Intake

On/Off

Rocker

Switch

Exhaust

Gas Inlet side

and power cord

outlet

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 44 45

Pas de commentaire

Archgard Optima 40 Spécifications Page 13