Archgard 72-DVT30N Manuel d'utilisateur télécharger pdf (Page 25)

72-DVT30N

LOG PLACEMENT

The Archgard pan burner and fiber logs are designed to give a realistic fire package, and are

created to look the same as the day they were originally installed. Care must be given when

first installing the logs, and if removed for servicing, as they can be damaged or broken if not

handled properly.

After opening the log set package, inspect the logs to ensure that no damage has occurred in-

side the package. Please report any damage immediately to your Authorized Archgard Dealer.

Gas and vent connections must be made before installing the logs and embers on the pan

burner.

NOTE: Improper placement of logs and/or embers may cause sooting on the internal parts and

glass, and will not be covered under warranty. Do not use broken or damaged logs.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use

only parts specifically approved with this appliance may result in property damage

or personal injury.

The pan burner has pins and rests to accept the logs. Locate the grate and embers and place

them on the pan burner as shown. Refer to the pictured instructions on the following pages that

will show how to place the logs. The bottom of each log has a 1 or 4 digit code that can be used

as a reference to help locate the correct log.

IMPORTANT: Pins & holes must be aligned with logs & burner.

NOTE: Installing the fiber logs in any other position other than shown will result in flame

impingement causing sooting of the logs, brick liner and ceramic glass viewing area.

Locator Pins

LOG RESTS

LOCATOR PINS

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 52 53

Pas de commentaire

Archgard 72-DVT30N Manuel d'utilisateur Page 25