Archgard 72-DVT30N Manuel d'utilisateur télécharger pdf (Page 43)

72-DVT30N

ADJUSTING PRIMARY AIR

CHANGING MAIN BURNER ORIFICE

NOTE: (Fig.1) is to give an example of a correct and incorrect flame pattern. It is not a true rep-

resentation of what the Optima 72 will look like in your home environment.

FLAMES...

The left side shows

correct adjustment. The

right side shows yellow

sooty flames requiring

increase in shutter open-

ing or cleaning of shutter

area due to lint buildup.

Fig.1

1. Remove the glass door. Follow GLASS DOOR REMOVAL instructions within this

manual.

2. Remove the wing nut and washer from the Primary Air Sleeve

3. Locate & slide the Primary Air Sleeve fully toward the left. This will allow the sleeve to

disconnect from the burner tube. Follow ADJUSTING PRIMARY AIR instructions within

this manual for reassembly.

4. Remove the grate and front logs from the pan burner. See LOG PLACEMENT for

instructions.

5. Unscrew the two mounting screws that are located at the back rear of the pan burner.

6. Carefully remove the burner with Air Sleeve by lifting it out.

7. Use a 1/2” (13 mm) wrench to remove the orifice cap.

8. Change the orifice cap to the fuel type desired. Use a small quantity of gas thread seal

compound. Do not over tighten.

9. Reverse steps 6 to 1.

THIS APPLIANCE IS EQUIPPED FOR NATURAL GAS. An additional CONVERSION kit is required to

convert for Propane use. To order the CONVERSION kit, please contact your Authorized Archgard

Dealer.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 52 53

Pas de commentaire

Archgard 72-DVT30N Manuel d'utilisateur Page 43