Archgard Optima 40 Spécifications télécharger pdf (Page 33)

Optima 40 - SB 33

1. Open the lower grills.

2. The pressure test taps are located on the valve. The taps are located in the gas valve front face.

The inlet is marked ‘IN’ and the outlet is marked ‘OUT’. See Fig.1.

3. Loosen the set screw inside the tap with a Philips (+) screwdriver.

4. Connect a ¼” (6 mm) rubber tube to the tap post and a manometer.

5. Verify that the readings obtained are within specs (as shown on the appliance rating plate)

6. Be sure to tighten the set screw inside the tap after you have finished taking pressure readings.

7. Check for leaks.

CHECKING INLET AND OUTLET GAS PRESSURE

CHECKING AND ADJUSTING PILOT

Fig.1

CONVERTIBLE PILOT ORIFICE

The pilot assembly is convertible to the type

of gas being used, simply unscrew the body

by using a 7/16” (11 mm) wrench, turn ¼

open then push the small metal tab across to

the other side of the body and retighten. Call

your local Authorized Archgard Dealer to

purchase the correct fuel conversion kit

for your gas appliance.

7/16” (11 mm)

WRENCH

(HERE)

The pilot flame should have the characteristic

as shown in the illustration to the right. The

flame should not have yellow tips but should

engulf the thermocouple and thermopile. It

can be adjusted by turning the screw marked

“pilot” on the control valve.

Thermopile

Burner Ports

Electrode

Thermocouple

THTP

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Pas de commentaire

Archgard Optima 40 Spécifications Page 33