Archgard Optima 40 Spécifications télécharger pdf (Page 7)

Optima 40 - SB 7

MINIMUM FIREPLACE DIMENSIONS

SIDE VIEW

APPLIANCE DIMENSIONS

DIMENSIONS

A 28” (711 mm)

B 18 ½” (470 mm)

C 14” (356 mm)

D 14 ⅛” (359 mm

DSK-40 or ESK-40

(STANDARD SURROUND)

E 44” (1118 mm)

F 29 ⅝” (752 mm)

LSK-40 (LARGE FLAT SURROUND)

E 47 ¼” (1200 mm)

F 31 ⅜” (797 mm)

G 22 ⅜” (568 mm)

H 3 ¾” (93 mm)

I 1 ¼” (32 mm)

DIMENSIONS

J 22 ½” (572 mm)

K 15 ¾” (400 mm)

L 19” (483 mm)

M 29 ⅝” (752 mm)

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts

specifically approved with this appliance may result in property damage or personal injury.

The installer must mechanically attach the marking supplied with the gas fireplace insert to the inside of

the firebox of the fireplace into which the gas fireplace insert is installed. Cutting of any sheet-metal

parts of the fireplace, in which the gas fireplace insert is to be installed, is prohibited. If the factory-built

fireplace has no gas access hole(s) provided, an access hole of 1½” (37.5 mm) or less may be drilled

through the lower sides or bottom of the firebox in a proper workmanship like manner. This access hole

must be plugged with non-combustible insulation after the gas supply line has been installed. The

fireplace flue damper can be fully blocked open or removed for installation of the gas fireplace insert.

The fireplace and fireplace chimney must be clean and in good working order and constructed of non-

combustible materials. The chimney cleanouts must fit properly. Refractory, glass doors, screen rails,

screen mesh and log grates can be removed from the fireplace before installing the gas fireplace insert.

Smoke shelves, and baffles may be removed if attached by mechanical fasteners. Trim panels must

not seal ventilation openings in the fireplace.

TOP VIEW

1 2 3 4 5 6 7 8 9 10 11 12 ... 44 45

Pas de commentaire

Archgard Optima 40 Spécifications Page 7